| Protective film on the sheet indicates which side is | | | | too tight. Install remaining screws required in |
| to be positioned to the outside. To assure that | | | | upper, lower and mid points of sheet, firmly |
| the co-extruded U.V. protective layer is facing in | | | | attaching sheet to frame. Install adjacent sheet in |
| the proper direction, remove just before | | | | same manner. |
| installation. Begin with walls. Cut out for shutters | | | | 5) Place Narrow Profile Cap at sheet joining |
| prior to installation of the sheet. Cut out for fan | | | | locations, { A }. First drill 3/16" holes in Cap, 1" |
| after sheet is already in place. | | | | from each end & every 10" - 12" on-center. |
| 1) Leave film on sheet. Cut sheets to length | | | | Cap overlaps U-Profile, on bottom of walls { B }, |
| & width as required. Clean out channels. | | | | and bottom edges of roof sheets, { C }. |
| 2) Cover channels at upper edge of gable end wall | | | | 6) Install U-Profile as required. Drill 1/16" weep |
| sheets with Aluminum Tape, { D}. Top edge of | | | | holes, every 12", in the U-Profile to be placed on |
| the roof sheets most often closed with aluminum | | | | the lower edge of the sheets. Position U-Profile |
| tape, resting on blocking, { G & H }, but | | | | over lower edge of roof with long leg of U-Profile |
| may be capped with Aluminum U-Profile if no | | | | facing up, { C }. U-Profile at lower edge of roof |
| blocking and rafters at 24-1/8" on-center. Top | | | | sheets held in place with 3/8" self-drill screws. Side |
| edge of gable end sheets covered with the | | | | wall sheets of freestanding greenhouses (front |
| Corner Trim, { D }. | | | | wall for attached) have U-Profile at on top and |
| 3) Position sheet on frame, so outer ribs are | | | | lower edges of the sheets, gable ends on bottom |
| supported by minimum of 1/2" of frame. | | | | only, tape & Corner at top. Pressure of |
| 4) Drill 1/4" hole/s in mid-sheet fastening points | | | | sheet against frame holds U-Profile in place. |
| (see Positioning & Attachment notes on page | | | | 7) Install Corner Trim, predrill 3/16" screw holes, |
| 15) and attach to frame, via screws with 3/4" | | | | 1" from each end and every 12". Corners overlap |
| sealing washers. After you are assured of proper | | | | U-Profile. |
| alignment of sheet, make screws snug, but not | | | | 8) Place sealant at trim joints as required. |