How to Build a Sturdy Awning

Many people would jump at the chance to put anGently remove the grommets from the tarps
awning right in their own homes. The problem isend. Make sure that the grommets should be
getting a professional builder to build and install anfolded and carefully sewn together and leave
awning takes some serious cash outlay. Building ansmall channels between the two ends. If you
awning yourself is a good idea for it can save youwould look at the channel, it should allow the
as much as 80 percent. However, you need to be¼ inch steel rod to slide inside without any
aware of the procedure needed to get theproblems.
awning to work. Your best guide at this point is toThe nylon rope should be cut into two sections
learn the process so that you can avoid thoseand tied to each washer at the end. After doing
costly mistakes.this, the washes should be tied to each section of
Some of the parts you might need are: a hugethe cut rope. Then each end of the rope is to be
tarp. This tarp will be the main component thattied into slipknots so it can be used as stakes for
provides cover in the awning. It should be 8 to 10the tent.
feet. You also need to get long nylon rope fromYou should also make a note to smoothen out
20 to 50 feet. Gather some large washers, a longthe rough edges of the washer to get a longer
steel rod of 8 feet and sectioned every ¼rope life.
of an inch. You should also get some extendableAfter the steel pole and ropes have been set,
tent poles and rubber tipped clamps for holdingyou can now deploy the awning on a bus. You
the awning in place.have to make sure that the awning is properly
The rubber clamp is used so that it prevents theset up. Take the steel rod and make sure it is slid
paint from being scratched. A 3 inch clamp is theinto the tarp. The 8 inch channel should then be
most ideal. You should exercise some judgment inslid on the door side that slides. This requires 2
choosing the steel rods. Some people may find itpeople to work the task. This should take 5 to 10
too long. Getting a pole that is a bit shorter mightminutes. Once this is set up, the awning can be
let the paint get chipped or scraped. Usingretracted and loved according to your taste.
stainless steel rods will only make you spendIt isn't hard to build an awning but you need to be
more money to get the paint fixed.familiar with the way it works to know how to
Procedure for assemblingbuild it.